WRX

BeagleBone Black SDR cape: software-defined receiver (0-30 MHz), web-controlled, ADC + FPGA + GPS

WRX

Posted by Angel on 2014-10-23T00:41:27-04:00

February 2015: See the status update at the homepage link below.

Here’s a prototype of a cape that turns your BeagleBone Black into a web-controlled shortwave receiver. Several simultaneous web connections are possible each of which can independently tune a channel of the receiver. See the project homepage for details of the web interface.

The cape consists of an active antenna coupler, followed by an HF low-pass filter, +20 dB amplifier, 14-bit ADC and Xilinx LX25 FPGA connected to the Beagle over the SPI0 connection. For the software-defined GPS a Skyworks SE4150 GPS front-end chip connects to the FPGA. The GPS is used to accurately calibrate the receivers.

Since low cost is a primary goal this cape is not designed to be a general purpose FPGA development board. Existing capes (LOGi-Bone etc.) are already available. However, the FPGA is programmed from the Beagle and you can download any firmware you choose. The open-source software and firmware will allow experimentation with SDR and SD-GPS design.

Comments are not currently available for this post.