The Trainer board is an expansion / breakout board for the BeagleBoard that provides level translated interfaces for: I2C, SPI, multiple GPIO's, standard prototyping area, Arduino compatible ATmega328.

Posted by Angel on 2010-04-25T22:42:41-04:00

The Trainer board is a expansion / breakout board for the BeagleBoard that provides the following interfaces:

  • I2C interface (level translated to 3.3V or 5V)
  • SPI interface (level translated to 3.3V)
  • multiple GPIO’s (level translated to 3.3V)
  • standard 0.1″ x 0.1″ prototyping area
  • Arduino compatible ATmega328 processor (user selected jumper to run at 3.3V or 5V)
  • ATmega328 processor can run SparkFun’s SerIO serial command software
  • BeagleBoard can communicate to the ATmega328 processor via its second serial port
  • BeagleBoard can control the power to the ATmega328 processor
  • The Trainer board attaches to the BeagleBoard via the expansion connector. The board connects to the back of the BeagleBoard and is the same physical size: 3.1″ x 3.0″.

Contact =

Comments are not currently available for this post.